Hardware Description

Front Panel

The Front Panel of the MIL-S1600S switch consists of 16 10/100Base-TX RJ-45 ports The LED Indicators are also located on the front panel of the switch.

RJ-45 Ports (Auto MDI/MDIX): 16 10/100 auto-sensing for 10Base-T or 100Base-TX connections. (In general, MDI means con- necting to another hub or switch while MDIX means connecting to a workstation or PC. Therefore, auto MDI/MDIX means that you can connect to another switch or workstation without changing non- crossover or crossover cabling.)

LEDs Indicators

The LED Indicators gives real-time information of systematic opera- tion status. The following table provides descriptions of LED status and their meaning.

LED	Status	Description
Power	Green	Power On

	Off	Power is not connected

LK/ACT	Green	The port is connected with
		operating device.

	Blinks	The port is receiving or
		transmitting data.

	Off	No device attached.

Rear Panel

The 3-pronged power plug is located at the rear Panel of the MIL- S1600S switch as shown in Figure 2-2. The switch will work with AC in the range 100-240V AC, 50-60Hz

Desktop Installation

Set the switch on a sufficiently large flat space with a power outlet nearby. The surface where you put your switch should be clean, smooth, level and sturdy. Make sure there is enough clearance around the switch to allow attachment of cables, power cord and allow air circulation.

Power ON

Connect the power cord to the power socket on the rear panel of the switch. The internal power supply in the switch works with AC in the voltage range 100-240VAC, frequency 50~60Hz.

Check the power indicator on the front panel to see if power is prop- erly supplied.