Milan Technology MIL-S800 manual Hardware Installation, Quick Installation

Chapter 2 Hardware Installation

2-1 Quick Installation

•The MIL-S800 should be placed in a well-ventilated room with proper temperature and humidity.

•

•

Do not place the unit near water.

The maximum distance between the port to the standard network interface is 100 meters.

•For desktop installation, ensure the surface is clean, smooth, level and sturdy. Apply self-adhesive rubber feet to the bottom of the switch near the corners.

•For wall installation, place two screws securely into the wall. Slide the cross recesses on the bottom of the MIL-S800 onto the screws.

•For mounting the MIL-S800 on a metal surface, install magnets as shown in instructions and apply to surface.

•Visually check that the power cord is not damaged. Plug the female end of the cord into the rear of the MIL-S800 and the male end (power converter) into a power outlet.

•Do not plug a phone jack connector into any RJ-45 port. This may cause damage. Use only twisted-pair cables with RJ-45 connectors that conform to FCC standards.

Figure 4. Installation of switch

4