N-Tron 105TX-POE, 105FX-POE user manual DIN-Rail Mounting

Page 8

DIN-Rail Mounting

Install the unit in a standard DIN rail. Recess the unit to allow at least 2” of horizontal clearance for CAT5e cable bend radius.

To install the unit to 35mm industrial DIN rail, place the top edge of the included mounting bracket on the back of the unit against the DIN rail at a 15° angle as shown. Rotate the bottom of the unit to the back (away from you) until it snaps into place.

To remove the unit from the 35mm industrial DIN rail, place a flat head screwdriver into the release clip found at the bottom of the unit, and apply downward force on the clip until it disengages from the bottom of the unit from the DIN rail. Rotate the bottom of the unit towards you and up at an approximate 15° upward angle to completely remove the unit.

Most N-Tron™ products are designed to be mounted on industry standard 35mm DIN rail. However, DIN rail mounting may not be suitable for all applications. Our Rack Mount Assembly (P/N: 900-RM) may be used to mount the

105TX/FX-POE enclosures to standard 19" racks as an option.

Rev. 041008

8

Image 8
Contents Rev Industrial Power over Ethernet Installation Guide Where XX = ST or SC and YY = -15, -40, orContact Information Rev Hazardous Location Installation Requirements Key Features Functional OverviewPackage Contents CleaningInstallation UnpackingDIN-Rail Mounting LED Mode of Operation Front PanelPOE SPDApplying Power Top View Tron Grounding Techniques for 105TX-POE and 105FX-POE RJ45 Connector Crimp Specifications Typical Applications Star Topology Ring Topology Connecting the Unit TroubleshootingFCC Statement Industry CanadaRegulatory Approvals Recommended Minimum Wiring Clearance Fiber Transceiver CharacteristicsConnectors Tron Limited Warranty