Installation, Recommended Tools and Supplies

SR4X-MM OM 5/14/02 11:38 AM Page 5

SR4X-MM Mirror-Mount Owner’s Manual

Installation

Parts for TERK SR4X-MM Mirror-Mount Antenna

(4)1⁄4"-20 x 2" Hex-Head Bolts

(4) 1⁄4"-20 Ext. Tooth	8.75"
(4) 1⁄4"-20 Ext. Tooth
Lock Washers
(4) 1 ⁄4" Flat Washers
(4) 1⁄4"-20 Hex Nuts	(4) Cable Tie Wraps
	36"

(1)Right-Angle Bracket

(1) 3 ⁄4" Ext. Tooth Lock Washer

(1) Connecting Bracket(1) 3 ⁄4" Flat Washer

(1) 3 ⁄4"-16 Hex Thin Nut

(1)TERK SR4X-MM Antenna Mast with 17'of Attached Coaxial Cables

with (2) separate plastic cases/clips

Figure 2. Verify that your TERK SR4X-MM Mirror-Mount package includes the above items. NOTE: All metal mounting hardware is stainless steel.

Recommended Tools and Supplies

•Any socket tool/wrench set (to tighten machine bolts and hex nuts)

•Any tool to help cable routing (e.g., flat dental pick, screwdriver, etc.)

•Grommets and silicone sealer (for cable routes)

Installation Precautions and Tips

•When selecting an antenna location, make sure the proposed site is the highest possible and does not interfere with the driver’s visibility of the road during vehicle operation.

•Also, at the proposed site, verify that there is at least a 20-degree clearance from any obstruction on all sides, including any metal hardware and exhaust stacks. Installation near fiberglass wind fairings is acceptable with minimal signal blockage.

•Prior to installation, turn off all audio systems and other electrical devices. Disconnect the (–) negative lead from the vehicle’s battery.

•At the installation site, locate and make a note of all fuel lines, hydraulic brake lines, and electrical wiring. Use extreme caution when cutting or drilling in and around these areas. Always wear protective eyewear when using tools.

continued on next page...

Installation 5