M-Audio Conectiv manual Hardware Connections

Page 8

8

Hardware Connections

7

ground

CD Player /

Turntable Line Level Sources

USB

Computer

Power Supply

(optional)

Channel 1

Channel 2

inin

Powered

Speakers

or PA

DJ Mixer

1.Connect Conectiv’s RCA Outputs to your amplifier, powered monitors, or mixer.

2.Connect your stereo headphones to Conectiv’s front-panel Phones output.

3.Connect a microphone to the 1/4” Microphone input on the front panel of the interface.

4.Connect your turntables or line-level sources to Conectiv’s RCA inputs.

5.Connect Conectiv’s USB port to an available USB port on your Mac or PC computer with a USB cable.

6.If your computer cannot supply sufficient USB bus power, or if you are using Conectiv in standalone mode (without a computer), connect a DC power adapter to the Power jack (13) on the rear of the interface. Conectiv requires a center-positive 9V DC 500 mA power supply.

If you are using

turntables, be

sure to connect each turntable’s ground wire to the grounding connector (12) on the rear of the

interface.

User Guide

Page 7 Page 9
Image 8
Page 7 Page 9
Contents User Guide Table of Contents Introduction Conectiv Features Conectiv has the following featuresWhat’s in the Box? Your Conectiv package contains the followingHardware Minimum System RequirementsOperating Systems Software Installation Controls and ConnectorsHeadphone Volume Knob VOL This knob Top PanelRear Panel Front PanelRCA Inputs Input A, Input B These RCA Microphone InputHardware Connections Using Conectiv Understanding Conectiv’s Audio RoutingMix Knobs Using Control Vinyl or CDs to Control Your DJ Software Headphone MonitoringStandalone Microphone Preamplifier Using Your Computer as an Effects ProcessorStandalone Phono Preamplifier Software Control Panel MacUsing Conectiv with a Computer TroubleshootingStandalone Mode User Guide Product Specs Warranty Terms and Registration Warranty Terms Warranty RegistrationAudio USA
Top Page Image Contents