MaxTech XT4861 user manual Installation, Attaching the Base, Connecting the Cable

Page 4

signal is re-enabled the monitor returns to normal operation.

The monitor enters DPMS OFF mode when the computer turns off both the Horizontal and Vertical Synchronization signals. This mode reduces the monitor’s power consumption to 3W. When the synchronization signals are re-enabled the monitor returns to normal operation.

Section 2 - Installation

2.1 Attaching the Base

Figure 2-1 Connecting the Base

Carefully place the monitor on its side or top.

Insert the hooks on the swivel base into the slots in the bot- tom of the monitor. Push down and forward on the base until the it snaps into place.

Place the display upright in an appropriate location.

2.2 Connecting the Cable

·Plug the 15-pin male connector on the video cable into the output

Figure 2-2 Monitor Connections

Expansion boards

COM1

COM2

LPT1

VIDEO

3

Image 4
Contents XT4861 Table of Contents Power Saving Modes Precautions When Using the MonitorGeneral Information Connecting the Cable InstallationAttaching the Base Monitor Controls and LEDs Controls and LEDsTroubleshooting Appendix a SpecificationsAppendix C Three Year Warranty Appendix B Video Cable PinoutHOW to Obtain Warranty Service Appendix D Notices FCC Class B StatementCanadian DOC Compliance Statement Disclaimer, Copyright, And Other Notices