MaxTech XT-7871 user manual Control and LED Locations

Page 5

Figure 3-2 Control and LED Locations

2

3

8

7

6

5

4

1.Master Power (On rear): Push to provide power to the monitor. This switch should be left ON for daily operation. Use the front panel On/Off control (3) to turn the monitor display on and off.

2.Power Saving Indicator: When lit, the monitor is in the DPMS OFF mode.

3.ON/OFF: Press this switch to turn the monitor display on, press again to turn the monitor display off.

4.Power On Indicator: When lit the monitor is powered on

5.Adjust: Press plus (+) to increase the setting for the selected OSD param- eter. Press minus (-)to decrease the setting.

6.Select: Press either button to enable the OSD display. Press (Ø) to select the next OSD parameter. Press (×) to select the previous OSD parameter.

7.Contrast Control: Adjusts the contrast of the display.

8.Brightness Control: Adjusts the display brightness.

4

Page 4 Page 6
Image 5
Page 4 Page 6
Contents XT-7871 Table of Contents General Information InstallationPrecautions When Using the Monitor Controls and LEDs Monitor Controls and LEDsControl and LED Locations On-Screen Display No picture, no LEDs lit TroubleshootingFront controls Appendix a SpecificationsAppendix B Video Cable Pinout Appendix C Power Saving Modes DpmsHOW to Obtain Warranty Service Appendix D Three Year WarrantyFCC Class B Statement Appendix E NoticesDisclaimer, Copyright, And Other Notices Canadian DOC Compliance Statement
Top Page Image Contents