MaxTech PCN2000 Series manual Contents

Page 3

 

Contents

 

Section One

Introduction

1

Section Two

Installation

2

Section Three Network Driver Installation ..

7

Section Four

Troubleshooting

7

Section Five

Cable Information

9

Section Six

Specifications

10

Section Seven Technical Support

11

Section Eight

Warranty, FCC And Other

 

 

Information

11

Section One - Introduction

Maxtech's PCN2000 Series PCMCIA net- work adapters are high performance, credit-card sized Ethernet network adapters. The adapter plugs into a PCMCIA Type II (or higher) slot providing a 16-bit bus interface and a 16 KB network data packet buffer. The adapter also features low-power- consumption design and is software configurable. The adapter complies with the Personal Computer Memory Card Industry Association (PCMCIA) Release 2.1 Type II standard and also with the IEEE 802.3 standards for Ethernet.

Minimum hardware requirements are an IBM AT (or better) fully compatible PC with 512K RAM running DOS 3.3 or higher, equipped with a PCMCIA Release 2.1 Type II slot.

1

Page 2 Page 4
Image 3
Page 2 Page 4
Contents PCN2000 Series Users Guide Repair Information Form Contents Model Section Two InstallationHardware Installation Unpacking Your Network AdapterAAdapter with 10Base-T Coupler Pcmcia Device Driver Installation Example On-screen prompt to start or stop the Network Function Test Testing The AdapterSection Four Troubleshooting Section Three Network Driver InstallationIncorrectly Installed Pcmcia Driver Not Excluding Memory Address D400- D7FFI/O Base Address and IRQ Conflict Section Five Cable Information Cable ProblemsSection Six Specifications Section Eight Warranty, FCC, And Other Information Five Year Limited WarrantySection Seven Technical Support Disclaimer, Copyright, And Other Notices FCC Compliance
Top Page Image Contents