MaxTech PCN2000 Series manual AAdapter with 10Base-T Coupler

Page 5

tions described in your PC's manual regarding static electricity discharge at all times when work- ing with your PC.

1.Turn off the computer

2.Hold the PCMCIA Ethernet adapter with the 68-pin female PCMCIA connector fac- ing an available PCMCIA Type II slot (refer to Figure 1-A or 1-B).

Figure 1-AAdapter with

10Base-T Coupler

68-pin female	Female Media
PCMCIA connector	Coupler connector

To

PCMCIA

Type 2.0

Slot

To Hub

10Base-T Media Coupler

Figure 1-BAdapter with 10Base-2/10Base-T Coupler

68-pin female	Female Media
PCMCIA connector	Coupler connector

To

PCMCIA

Type 2.0

Slot

To Hub

or

Thin Coax Cable

10Base-2/10Base-T Media Coupler

3

Image 5

Contents PCN2000 Series Users Guide Repair Information Form Contents Hardware Installation Section Two InstallationUnpacking Your Network Adapter ModelAAdapter with 10Base-T Coupler Pcmcia Device Driver Installation Example On-screen prompt to start or stop the Network Function Test Testing The AdapterSection Four Troubleshooting Section Three Network Driver InstallationI/O Base Address and IRQ Conflict Incorrectly Installed Pcmcia DriverNot Excluding Memory Address D400- D7FF Section Five Cable Information Cable ProblemsSection Six Specifications Section Seven Technical Support Section Eight Warranty, FCC, And Other InformationFive Year Limited Warranty Disclaimer, Copyright, And Other Notices FCC Compliance