M-Audio warranty Using Your Delta 1010-AI

4.Plug the other end of the second optical cable into the TOSLink input jack of your ADAT or other 8-channel optical capable device.

If you are using a single ADAT for this example, your setup should look like this:

Delta						ADAT
				-AI
1010toA					Ins To
					log d
					na ble
			nalog	Outs
	-AI	AT	ed
1010		D	bl
TA T toHost
DEL ADA
d
ble

ADAT

bled

Thru

1010 Delta

ADAT

Power

Using Your Delta 1010-AI

Adding the Delta 1010-AIto the Delta 1010 Recording System gives you the ability to convert your Delta’s 8 analog inputs into one ADAT Optical input and its 8 analog outputs into one ADAT Optical output. Your Delta 1010-AIand the Delta 1010 rack mount unit can also be used in a “standalone” mode, in which the Delta 1010 A/D converters send signal directly to the AI’s optical output, and the Delta 1010-AIoptical input connects directly to the 1010 rack unit’s D/A converters.

This can be done in several configurations using the front panel selection switches, as well as certain mixed modes or combinations of switches. These configurations, mixed modes, and standalone mode are covered in this section.

6