Link electronic GT701AP user manual Setting the IP Address

Page 15

3.The "Welcome" screen appears. From this point, you can configure the Access Point from one of its seven sub-menus

Setting the IP Address

The IP Address section allows you to setup IP Address, either DHCP or static IP mode. NOTE: Changing these settings is not required in most applications

Click on the “IP Address” selection and the “IP Address” page will appear.

Actiontec recommends keeping the unit’s default static IP address (192.168.0.240), but if it conflicts with another device in the network, you can enter a new address in the “IP Address” text box.

If your network requires the Access Point to run in Dynamic Host Configuration Protocol (DHCP) mode which dynamically assigns an IP address, you can change these settings from this screen.

14

Image 15

Contents Wireless Access Point Table of Contents Page Package Contents Introduction1Minimum System Requirements Front Panel Access Point FeaturesPower LED Wireless LEDLAN Port Power PortReset Button Rear PanelTechnical Support Creating a Wireless Network Wireless2 Networking BasicsTo add wireless networking to an established wired network Extending a Wired NetworkCreating a Wireless Network from a Single Computer Installing Access Point Before InstallingConnecting the Access Point Placing or Mounting the Access Point Configuring the Access Point Making a Connection Setting Up Access PointViewing The Control Panel Setting the IP Address Basic Settings Page WEP 802.1x Security To EnableWPA Security To Enable WPAAdvanced Settings To Enable WPA withMAC Authentication Access Control Information AdministrationSave and Restart Upgrading Your Access Point’s FirmwareAssociated Stations To Upgrade Your Access Point’s FirmwareHow far can I be from the Access Point and still connect? Troubleshooting & FAQsTroubleshooting Frequently Asked QuestionsWill cordless phones interfere with the Access Point? How fast is the wireless network?Can I share my Internet connection using the Access Point? Does the Access Point provide load balancing capabilities?What is WEP? How do I make a HEX-based WEP key? What is WPA?Windows 98 and 98 SE Setting Up Static IPPage Page 192.168.0.2 Windows Me Page Dont include the periods they are automatically entered Windows Page Page Internet Protocol TCP/IP Properties window appears Windows XP Connections option Internet Protocol TCP/IP Properties window appears 192.182.0.2 Aptitude SpecificationsBSecurity ManagementUsability FeaturesOperating Range Specifications InterfaceWireless Data RatesEnvironmental RoamingStandards Compliance SecurityPower Limited WarrantyCompliance Certification Regulatory Compliance Notices ModificationsClass B Equipment Page Limited Warranty Published specifications or user guide