Link electronic GT701AP Regulatory Compliance Notices, Modifications, Class B Equipment

Page 49

Notices

Regulatory Compliance Notices

Class B Equipment

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that inter- ference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by implementing one or more of the following measures:

sReorient or relocate the receiving antenna;

sIncrease the separation between the equipment and receiver;

sConnect the equipment to an outlet on a circuit different from that to which the receiver is connected;

sConsult the dealer or an experienced radio or television technician for help.

Modifications

The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Actiontec Electronics, Inc., may void the user’s authority to operate the equipment.

Declaration of conformity for products marked with the FCC logo – United States only.

This device complies with Part 15 of the FCC Rules. Operation is subject to the fol- lowing two conditions:

1.This device may not cause harmful interference;

2.This device must accept any interference received, including interference that may cause unwanted operation.

48

Image 49

Contents Wireless Access Point Table of Contents Page Introduction1 Package ContentsMinimum System Requirements Power LED Access Point FeaturesWireless LED Front PanelReset Button Power PortRear Panel LAN PortTechnical Support Creating a Wireless Network Wireless2 Networking BasicsTo add wireless networking to an established wired network Extending a Wired NetworkCreating a Wireless Network from a Single Computer Before Installing Installing Access PointConnecting the Access Point Placing or Mounting the Access Point Configuring the Access Point Making a Connection Setting Up Access PointViewing The Control Panel Setting the IP Address Basic Settings Page WEP 802.1x Security To EnableWPA Security To Enable WPAAdvanced Settings To Enable WPA withMAC Authentication Access Control Information AdministrationSave and Restart Upgrading Your Access Point’s FirmwareAssociated Stations To Upgrade Your Access Point’s FirmwareTroubleshooting Troubleshooting & FAQsFrequently Asked Questions How far can I be from the Access Point and still connect?Can I share my Internet connection using the Access Point? How fast is the wireless network?Does the Access Point provide load balancing capabilities? Will cordless phones interfere with the Access Point?What is WEP? How do I make a HEX-based WEP key? What is WPA?Windows 98 and 98 SE Setting Up Static IPPage Page 192.168.0.2 Windows Me Page Dont include the periods they are automatically entered Windows Page Page Internet Protocol TCP/IP Properties window appears Windows XP Connections option Internet Protocol TCP/IP Properties window appears 192.182.0.2 Security SpecificationsBManagement AptitudeUsability FeaturesWireless Specifications InterfaceData Rates Operating RangeStandards Compliance RoamingSecurity EnvironmentalLimited Warranty PowerCompliance Certification Modifications Regulatory Compliance NoticesClass B Equipment Page Limited Warranty Published specifications or user guide