Metra Electronics 99-7511S ISO Mount Radio Provision, Radio Housing. Figure C

Page 5

99-7511S KIT ASSEMBLY

ISO MOUNT RADIO PROVISION

*Note: Refer also to the instructions included with the aftermarket radio.

A

1Attach the filler trim panel to the back of the radio housing at the bottom edge. (Figure A)

2Mount the ISO Brackets to the radio using the screws supplied with the radio. (Figure B)

REAR OF RADIO HOUSING

3 Slide the radio into the radio housing until it snaps into place. (Figure C)

4Snap the Trim Plate onto the front of

the Radio Housing. (Figure C)

B

 

5Snap the pocket into the bottom open- ing of the radio housing. (Figure D)

FILLER TRIM PANEL

Continue to final assembly.

DC

3

Image 5
Contents 99-7511S Dash Disassembly Mazda 6 DIN Radio Provision 99-7511S KIT AssemblyISO Mount Radio Provision Radio Housing. Figure CDouble DIN/STACKED ISO Mount Units Provision Final Wiring Connections Final Assembly99-7511S Instructions