Metra Electronics 99-7511S installation instructions Double DIN/STACKED ISO Mount Units Provision

Page 6

99-7511S KIT ASSEMBLY

DOUBLE DIN/STACKED ISO MOUNT

UNIT(S) PROVISION

*Note: Refer also to the instructions included with the aftermarket radio.

1Attach the filler trim panel to the back of the radio housing at the bottom edge. (Figure A)

2Cut and remove the center bar from the Radio Housing. (Figure B)

A

REAR OF RADIO HOUSING

3 Snap the Double DIN brackets to the inside edge of the Radio Housing.

(Figure C)

B

4Slide the Double DIN or stacked ISO mount unit(s) into the bracket/radio housing assembly and secure to the assembly using the screws supplied with the unit(s). Snap the DDIN Trim Plate onto the front of the Radio Housing. (Figure D)

FILLER TRIM PANEL

Continue to final assembly.

DC

4

Image 6
Contents 99-7511S Dash Disassembly Mazda 6 99-7511S KIT Assembly DIN Radio ProvisionRadio Housing. Figure C ISO Mount Radio ProvisionDouble DIN/STACKED ISO Mount Units Provision Final Assembly Final Wiring Connections99-7511S Instructions