IR Code Configuration

How to Resolve IR Code Conflicts

In the event that IR commands from other remote controls conflict with the supplied RMT-2IR remote control, changing the remote channel will alleviate this issue. The RMT-2IR remote control and the 2X4 Switcher/Splitter for HDMI have DIP SWITCHES for configuring the remote channel that both units use to communicate. These settings must match each other for proper operation. The 2 DIP SWITCH bank on the RMT-2IR is located underneath the battery cover. The 8 DIP SWITCH bank for the 2X4 Switcher/Splitter for HDMI is located inside of the unit. *DIP SWITCH 1 and 2 on the RMT-2IR correspond to DIP SWITCH 3 and 4 on the 2X4 Switcher/Splitter for HDMI.

NOTE: *DIP SWITCHES 1, 2, and 5 through 8 are not used on the 2X4 Switcher/Splitter for HDMI.

Because the procedure for changing channels requires the main unit to be disassembled, this procedure should only be done if there are IR conflicts present in your setup.

Disconnect power from unit before starting. Remove all cabling from unit.

To open the 2X4 Switcher/Splitter for HDMI Unit, remove all screws from the sides and underside of the unit. Remove the hex nuts above each HDMI connector. Slide the unit apart carefully to expose the internal PCB and the 8 DIP SWITCH bank.

Carefully slide the PCB back into the unit. Being careful not to over tighten the hex nuts, screw them back in above each HDMI connector and on the RS-232 serial connector. Screw all of the screws from the sides and underside of the unit back into the unit, again being careful not to over tighten the screws. Plug all cabling back into its proper location on the unit. Reconnect power to the unit and test for IR conflicts.

Remote

Remote Channel 1:		Remote Channel 2:
Remote Channel 1:		Remote Channel 2:
Default


1	2	1	2

Remote Channel 3:		Remote Channel 4:




1	2	1	2

2X4 Switcher/Splitter For HDMI

Remote Channel 1: Default

Remote Channel 3:

1 2 3 4 5 6 7 8

Remote Channel 2:

Remote Channel 4:

1 2 3 4 5 6 7 8