EN
LANCOM 7111 VPN – LANCOM 8011 VPN
Chapter 3: Basic configuration
Enable DHCP server?
Disable the DHCP server function in the LANCOM router if you would like to have a different DHCP server assign the IP addresses in your LAN.
3.1.2Configuration protection
The password for configuration access to the LANCOM router protects the configuration against unauthorized access. The configuration of the router contains a considerable amount of sensitive information such as your Internet access information. We therefore strongly recommend protecting it with a password.
The setup wizard for the basic configuration automatically disables remote configuration access via ISDN, thus protecting your configuration against tampering. ISDN remote configuration access can be enabled at any time
using the security wizard (see ’Have you permitted remote configuration?’ →page 69).
3.1.3Settings for the DSL connection
For the WAN connection it may be necessary to enter the transfer protocol being used. The wizard will e.g. automatically enter the correct settings for major DSL providers. You only need to enter the protocol used by your access provider if the wizard does not list your provider.
3.1.4Settings for the ISDN connection
Set up the basic configuration of your ISDN connection if required. You will need the following data:
One or more ISDN MSNs on which the router will accept calls. MSNs are ISDN subscriber numbers that are assigned to you by your telephone pro- vider. They are normally entered without an area code. These numbers are only relevant for the router functions (LAN to LAN coupling, RAS), not for remote configuration and LANCOM VPN Option.
A dialing prefix for access to the public telephone network. This is nor- mally required only when using an ISDN PBX. '0' is the usual prefix. It is used for all outgoing calls.
Finally, you should know whether your telephone provider transmits an ISDN
30