Lancom Systems 8011 VPN, 7111 VPN manual Entering the password in the web browser

Page 36

EN

LANCOM 7111 VPN – LANCOM 8011 VPN

Chapter 3: Basic configuration

In the following 'Security settings' window, specify a password for config- uration access. Note that the password is case-sensitive and ensure that it is sufficiently long (at least 6 characters).

You may specify whether the device may only be configured from the local network or whether remote configuration via the WAN (i.e. a remote net- work) is also permissible.

Please note that enabling this will also permit remote configuration via the Internet. You should always make sure that the configuration access is suitably protected, e.g. with a password.

Remote configuration via a direct ISDN connection is available independ- ently of the WAN remote configuration: in this case, the configuration PC establishes a direct dial-up ISDN connection to the LANCOM router, for example using Windows Dial-Up Networking. ISDN remote configuration can be enabled by specifying an MSN/terminal device selection digit for it. In this case, the LANCOM router will accept calls on that MSN/terminal device selection digit and can be remotely configured via the ISDN con- nection.

Confirm your selection with Apply.

In the next window, select your DSL provider from the list that is displayed. Confirm your choice with Apply.

If you select 'My provider is not listed here,' you must enter the transfer protocol used by your DSL provider manually in the next window. Confirm your choice with Apply.

Entering the password in the web browser

When you are prompted for a user name and password by your web browser when accessing the device in the future, enter your personal values to the corresponding fields. Please note that the password is case-sensitive.

If you are using the common configuration account, enter the corresponding password only. Leave the user name field blank.

Entering the configuration password

36

Image 36

Contents Lancom 7111 VPN Lancom 8011 VPN Lancom Systems GmbH, Wuerselen Germany. All rights reserved Security settings PrefaceModel variants This documentation was compiled … Info@lancom.deContents Providing dial-up access Linking two networksSending faxes with Lancapi Troubleshooting AppendixIntroduction Which use does VPN offer?Conventional network infrastructure IsdnNetworking via the Internet Firewall Denial-of-Service Protection Quality-of-Service / Traffic managementWhat does a router do? Internet access for a LAN e.g. via DSL or Isdn Bridgehead to the WANAreas of deployment for routers LAN to LAN coupling via VPN or IsdnRemote access to the company network via VPN or Isdn What can your Lancom router do?Conventional via Isdn Lancom Quality of Service Installation Package contentsSystem preconditions Access to the LAN via the TCP/IP protocol Introducing Lancom routerStatus displays Front sideLED remains lit green Online LED indicates the overall status of all WAN portsFlashing Power LED but no connection? LancomConnection status of the WAN connection Data traffic via the WAN connectionConnection status of Isdn S0 connection Connection status of the serial configuration port 7111 VPN, for both Isdn B channels with Lancom 8011 VPNLCD display Hardware installation Back of the unitInstallation Software installation Starting Lancom setupWhich software should you install? Basic configuration 1 TCP/IP settingsWhich information is necessary? New LAN-fully automatic configuration possible Configure manually nevertheless?Information required for manual TCP/IP configuration IP address and netmask for the Lancom routerConfiguration protection Settings for the DSL connectionSettings for the Isdn connection Enable Dhcp server?Instructions for LANconfig Start up LANconfig by clicking Start Programs LancomLANconfig Connect charge protectionComplete the configuration with Finish Instructions for WEBconfig Network without Dhcp serverStarting the wizards in WEBconfig Network with Dhcp serverOr with a name as discribed above WEBconfig main menu will be displayed Entering the password in the web browser TCP/IP settings to workstation PCs IP address assignment via the Lancom router defaultIP address assignment via a separate Dhcp server Manual IP address assignmentSetting up Internet access Does the setup wizard know your Internet provider?User name and password Additional information for unknown Internet providersIsdn dial-in number User name and password Additional connection optionsDynamic channel bundling Isdn only LANconfig Quick access to the setup wizards Complete the configuration with ApplyAlways configure both sides Linking two networksSecurity aspects What information is necessary? General informationName of the remote station is needed for its identification Settings for the TCP/IP router Settings for the IPX router DNS access to the remote LANExtranet VPN Settings for NetBIOS routing Perform the configuration on both routers, one at a time Ping quick testing for TCP/IP connections Providing dial-up access Which information is required?Isdn calling line identity CLI Coupling EntrySettings for TCP/IP Settings for IPXWAN Settings for the dial-in computer Dial-up via VPNDial-up via Isdn Instructions for LANconfig Providing dial- up access Sending faxes with Lancapi Installation of the Lancom Capi fax modem Installation of the MS Windows fax service Select the option Printers and Faxes from the control panelSend a fax with the MS Windows fax service Sending a faxSend a fax with any given office application Sending faxes with Lancapi Security settings Security settings wizardWizard for LANconfig Wizard for WEBconfig Firewall wizardSecurity checklist Configuration under WEBconfigRules Have you assigned a password for the configuration? Have you permitted remote configuration?Have you activated the Firewall? Do you make use of a ’Deny All’ Firewall strategy?Have you closed critical ports with filters? Troubleshooting Problems with the cabling?No WAN connection is established DSL data transfer is slowCable testing Unwanted connections under Windows XPIncreasing the TCP/IP window size under Windows LAN statisticsTroubleshooting Performance data and specifications AppendixRights for up to 16 administrators Contact assignment DSL interfaceISDN-S0interface Pin RJ45 socketConfiguration interface Outband CE declaration of conformityEthernet interfaces 10/100Base-T Pin mini-DIN socketNumerics Installation IPX conventions IPX router SettingsConnector cable Channel Data compression Dial-innumber Connector cable LAN to LAN coupling 14, 15, 30NetBIOS NetBIOS proxy Netmask Network segment Package contents Packet size adaption PasswordNetBIOS Security aspects Server Setup Specify MSNSettings 28 , 32 Temperature Time WEBconfigCheck connection