Audiovox CDC-825, CDC-10R owner manual Infrared Sender

Page 10

9INFRARED SENDER

The wireless signal from the remote control is sent from this lens. For optimal range and performance of the remote control, always aim the Sender at the Remote Sensor blon the wired control unit. Do not let your finger interfere with the signal and make sure the lens does not become blocked by dirt, dust, etc. If necessary, clean the lens with a soft dry cloth or cotton swab.

NOTES ON REMOTE CONTROL USE:

l The remote control operates on a 3 volt lithium battery (type CR-2025). Install the battery into the compartment at the bottom of the remote control, making sure to observe correct polarity (match “+” side of battery to “+” indication on compartment).

lIf remote control fails to operate, always check battery condition and replace if necessary before servicing the unit.

lDispose of batteries properly. Do not heat, disassemble, or throw batteries into a fire.

lKeep the remote control away from areas where it may be exposed to heat, moisture or sunlight.

9

Page 9 Page 11
Image 10
Page 9 Page 11
Contents CDC-10R Condensation TemperatureHints for Correct and Safe Operation Interruptions in Sound SkippingHandling the Discs Loading Discs Into the Magazine USE of the CD MagazineRemoving Discs from the Magazine Loading the Magazine Into the Changer Removing the Magazine from the ChangerLCD Display Wired Control UnitCD Changer Operating Instructions Play / PauseTrack / Disc Shuffle SFL Power OFF Switch OFFTrack Search Track / Disc Repeat RPTBmRESETBUTTON Error SignsSpecifications BlREMOTE SensorTrack / Disc Shuffle SHF Disc Select +Track / Disc SCN Infrared Sender Troubleshooting Symptom Possible Cause RemedyMonth Limited Warranty
Top Page Image Contents