LevelOne FBr-1415TX user manual Remote Administrator Host/Port, Administrator Time-out, SPI Mode

Page 41

4.6.6 Miscellaneous Items

Remote Administrator Host/Port

In general, only Intranet user can browse the built-in web pages to perform administration task. This feature enables you to perform administration task from remote host. If this feature is enabled, only the specified IP address can perform remote administration. If the specified IP address is 0.0.0.0, any host can connect to this product to perform administration task. You can use subnet mask bits "/nn" notation to specified a group of trusted IP addresses. For example, "10.1.2.0/24".

NOTE: When Remote Administration is enabled, the web server port will be shifted to 88. You can change web server port to other port, too.

Administrator Time-out

The time of no activity to logout automatically. Set it to zero to disable this feature.

Discard PING from WAN side

When this feature is enabled, any host on the WAN cannot ping this product.

SPI Mode

When this feature is enabled, the router will record the packet information pass through the router like IP address, port address, ACK, SEQ number and so on. And the router will check every incoming packet to detect if this packet is valid.

41

Image 41
Contents LevelOne Copyright Specification is subject to change without noticeTrademarks FCC Interference StatementTable of Contents Appendix a TCP/IP Configuration for Windows 95/98 Functions and Features DMZ Host supported SPI Mode SupportedStatistics of WAN Supported Packet filter supportedUpnp Universal Plug and PlaySupported Packing ListSchedule Rule supported Function Color Status Description Panel LayoutFront Panel Port Rear PanelPort Description Procedure for Hardware Installation Ping Make Correct Network Settings of Your ComputerInstall the Software into Your Computers Page Configuring Broadband Router Start-up and Log Status Wizard Page Press Change Basic Setting Primary Setup WAN Type, Virtual ComputersDynamic IP Address Static IP Address1.6 L2TP PPP over EthernetPptp Virtual Computers Dhcp Server Press More Change Password Forwarding Rules Virtual Server Special AP Non-standard FTP port Miscellaneous ItemsIP Address of DMZ Host Security Settings Packet Filter Example Inbound FilterExample Filter field Outbound FilterPage Domain Filter Example URL Blocking URL Blocking EnablePage Control table MAC Address ControlIP Address MAC AddressAdministrator Time-out Remote Administrator Host/PortSPI Mode Discard Ping from WAN sideVPN PPTP/IPSec Pass-Through DoS Attack DetectionAdvanced Settings System Time System Log Mail Alert EnableIP Address for Syslog Server Smtp Server IP/PortMail Subject Dynamic DNS Example Enable Snmp Snmp SettingGet Community Set CommunityExample RIP Routing TableExample Press Add New Rule Schedule RuleAfter configure Rule 1à Delete Schedule EnableEdit Page System Log ToolboxFirmware Upgrade Reboot Backup SettingReset to default Domain Name or IP address for Ping Test Miscellaneous Items MAC Address for Wake-on-LANPrinterServer Configuring on Windows 95/98 PlatformsPage Page Configuring on Windows NT Platforms Configuring on Windows 2000 and XP Platforms Page Page Page Apply your settings Configuring on Unix-like based Platforms Page Page Page Command Mode Configuring on Apple PC Page Install TCP/IP Protocol into Your PC AppendixA TCP/IPConfiguration forWindows 95/98Page Set TCP/IP Protocol for Working with NAT Router Don’t input any value in the Gateway tab Page Page Restore directly when the router power on Reset to factory Default
Related manuals
Manual 37 pages 15.48 Kb