LevelOne FBr-1415TX user manual Routing Table, Rip

Page 51

4.7.5 Routing Table

Routing Tables allow you to determine which physical interface address to use for outgoing IP data grams. If you have more than one routers and subnets, you will need to enable routing table to allow packets to find proper routing path and allow different subnets to communicate with each other.

Routing Table settings are settings used to setup the functions of static and dynamic routing.

RIP

Routing Information Protocol (RIP) will exchange information about destinations for computing routes throughout the network. Please select RIPv2 only if you have different subnet in your network. Otherwise, please select RIPv1 if you need this protocol.

Static Routing: For static routing, you can specify up to 8 routing rules. You can enter the destination IP address, subnet mask, gateway, hop for each routing rule, and then enable or disable the rule by checking or unchecking the Enable checkbox.

51

Image 51

Contents LevelOne FCC Interference Statement Specification is subject to change without noticeCopyright TrademarksTable of Contents Appendix a TCP/IP Configuration for Windows 95/98 Functions and Features Packet filter supported SPI Mode SupportedDMZ Host supported Statistics of WAN SupportedPacking List Schedule Rule supportedUpnp Universal Plug and PlaySupported Panel Layout Front PanelFunction Color Status Description Rear Panel Port DescriptionPort Procedure for Hardware Installation Ping Make Correct Network Settings of Your ComputerInstall the Software into Your Computers Page Configuring Broadband Router Start-up and Log Status Wizard Page Press Change Basic Setting Primary Setup WAN Type, Virtual ComputersDynamic IP Address Static IP AddressPPP over Ethernet Pptp1.6 L2TP Virtual Computers Dhcp Server Press More Change Password Forwarding Rules Virtual Server Special AP Miscellaneous Items IP Address of DMZ HostNon-standard FTP port Security Settings Packet Filter Example Inbound FilterExample Filter field Outbound FilterPage Domain Filter Example URL Blocking URL Blocking EnablePage Control table MAC Address ControlIP Address MAC AddressDiscard Ping from WAN side Remote Administrator Host/PortAdministrator Time-out SPI ModeVPN PPTP/IPSec Pass-Through DoS Attack DetectionAdvanced Settings System Time Smtp Server IP/Port Mail Alert EnableSystem Log IP Address for Syslog ServerMail Subject Dynamic DNS Example Set Community Snmp SettingEnable Snmp Get CommunityExample RIP Routing TableExample Press Add New Rule Schedule RuleAfter configure Rule 1à Schedule Enable EditDelete Page System Log ToolboxFirmware Upgrade Backup Setting Reset to defaultReboot Domain Name or IP address for Ping Test Miscellaneous Items MAC Address for Wake-on-LANPrinterServer Configuring on Windows 95/98 PlatformsPage Page Configuring on Windows NT Platforms Configuring on Windows 2000 and XP Platforms Page Page Page Apply your settings Configuring on Unix-like based Platforms Page Page Page Command Mode Configuring on Apple PC Page Install TCP/IP Protocol into Your PC AppendixA TCP/IPConfiguration forWindows 95/98Page Set TCP/IP Protocol for Working with NAT Router Don’t input any value in the Gateway tab Page Page Restore directly when the router power on Reset to factory Default

Related manuals

Manual 37 pages 15.48 Kb