LevelOne FSW-2409TFX, FSW-1609TFX user manual 100Base-FX Module Installation

Page 14

100Base-FX Module Installation

The installation procedure for each module is the same. Additional information about each module is provided below.

To install any of the modules: (Includes SC or ST type connectors)

1.Locate the module slot in the switch’s rear panel.

2.Using a screwdriver, undo the two screws and remove the dust cover on the module slot.

3.Holding the module component-side up and connector- side in, gently slide the module along the guides and seat it in the internal connector.

4.Using a screwdriver, replace the two screws and tighten until snug.

10

Image 14

Contents LevelOne Page FCC Warning Table of Contents About this Guide PurposeTerms/Usage Overview of this User’s Guide Fast Ethernet Technology IntroductionSwitching Technology Features Page Page Unpacking and Installation UnpackingInstallation 100Base-FX Module Installation Rack Mounting Page Front Panel Auto-MDI/MDIX JacksRear Panel LED Indicators PC to Switch Connecting the SwitchHub to Switch 10BASE-T HubSwitch to Switch other devices Using straight cablePort Speed & Duplex Mode Technical Specifications GeneralPerformance RJ-45 PIN Specification RJ-45 Connector pin assignmentStandard RJ-45 receptacle/connector