Jasco HO98751 manual Hardware Installation

Page 8

V.Hardware Installation

1.Make sure your computer has all the necessary updates required to support USB. These can be found on Microsoft’s website.

2.Plug the USB connector of the Tetrahub™ into the USB port of your computer or hub. The power LED should illuminate.

3.Windows® 98 or 98 SE users see section VII for driver installation.

Page 8

Image 8
Contents Instruction Manual Table of Contents Introduction Features II. OverviewIII. Safety Instructions IV. Power Mode Setting Page Hardware Installation VI. TetraHub Accessories VII. Software Installation Windows VIII. Troubleshooting Hub Not SeenIX. Technical Specifications FCC Compliance Statement FCC WarningXI. Limited Lifetime Warranty