Radio operation

1.Slide the switch ALARM ON/OFF/AUTO e into the position "ON".

2.To switch on, turn the volume controller OFF/BUZZ/VOLUME o until an audible »Click« is heard.

3.Using the volume controller OFF/BUZZ/VOLUME o now set the desired sound volume level.

4.Place the waveband selector switch t at the desired frequency range (FM/AM).

5.Adjust the tuning regulator d to select the desired radio station. The frequencies can be read off from the frequency scale s.

6.To switch off, slide the switch ALARM ON/OFF/AUTO e into the position "OFF".

Note:

The radio is only switched off when the switch ALARM ON/OFF/AUTO e is at the positions OFF or AUTO. To simply turn the sound volume regulator o to very quiet, until a »Click« is heard, is not sufficient.

Setting up the telescope aerial

•Remove the telescope aerial w from its retainer and set it up.

•Extend the telescope aerial w completely.

To improve reception in the FM frequency range, slowly turn the end of the telescope aerial w in various directions. As soon as you have found a position with good reception from your desired radio station, leave the telescope aerial w in this position. For the reception of AM transmissions, an antenna is built into the device. For improved reception, alter the position of the device in radio mode.

- 9 -