Kingston Technology KNE24TP/RS, KNE16TP/RS manual C. Certification, CE Notice

Page 30

24

F.C.C. Certification

This device has been tested and found to comply with limits for Class A digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received; including interference that may cause undesired operation.

CE Notice

The official CE symbol indicates compliance of this Kingston Technology product to the EMC directive of the European Community. The CE symbol found here or elsewhere indicates that this Kingston product meets or exceeds the following standards:

❑EN50081-1“Electromagnetic Compatibility-generic emissions standard”

EN55022: “Limits and methods of measurement of radio interference characteristics.”

❑EN50082-1“Electromagnetic Compatibility-generic immunity standard”

IEC 801-2:“Electrostatic discharge requirements”

IEC 801-3:“Radiated immunity requirements”

IEC 801-4:“Electrical fast transient requirements”

❑EN60950 “Low Voltage Directive (LVD)”

❑Declaration of CE Conformity in accordance with the above standards has been made and is on file at Kingston Technology.

Kingston Technology Company

KNE24TP/RS User’s Guide - Rev. A01

Page 29 Page 30
Image 30
Page 29 Page 30
Contents Page Page Kingston Technology’s EtheRx Pro-Series Part No -001.A01Important Safety Instructions Wichtige SicherheitshinweiseTable of Contents Network Configurations Introduction Special Features Package ContentsJabber Lock-up Protection Design FeaturesRepeater Functions Fragment ExtensionAutomatic Partitioning/Reconnection Link TestFront Panel Hardware InstallationPower LED Utilization LEDsAUI LED UTP Port LEDsCascade Switch Using a Straight-Thru CableRear Panel STACK-IN STACK-OUT Cascade Config Stacking EtheRx HubsNetwork Configurations Ethernet 5-4-3 RuleEthernet Star Network Linear Bus Network Horizontal CascadingCascading with Stacked Hubs SegmentAppendices Appendix a Pin Assignments UTP Pin AssignmentsFig. A-3 AUI Connector on Rear Panel AUI Pin AssignmentsUTP Cable Wiring Appendix B Cabling GuidelinesCable Types Cabling Suggestions Use CAT 5 Equipment for Future 100Mbps NetworksCable Wiring Standards T568AAppendix C Specifications EtheRx Model KNE16TP/RSEtheRx Model KNE24TP/RS Appendix D Mounting Templates Rubber Feet for DesktopsBrackets for Rack Mounting Limited Warranty Statement Duration of WarrantyAppendix E Warranties and Notices Warranty Claim Requirements Free Technical SupportDisclaimers C. Certification CE Notice
Top Page Image Contents