Juniper Networks quick start M7i Internet Router Quick Start

M7i Internet Router Quick Start

■

■

When installing the router, do not use a ramp inclined at more than 10 degrees.

Manually installing the router requires two people to lift. To prevent injury, keep your back straight and lift with your legs, not your back. Do not attempt to lift the chassis by the power supply handles.

■The router should be mounted at the bottom of the rack if it is the only unit in the rack.

■When mounting the router in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack.

■If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the router in the rack.

■When removing or installing an electrical component, always place it component-side up on a flat antistatic surface or in an electrostatic bag.

■When you install the router, the ground connection must always be made first and disconnected last.

■Wire the DC power supply using the appropriate lugs. When connecting power, the proper wiring sequence is ground to ground, +RTN to +RTN, then -48 V to -48 V. When disconnecting power, the proper wiring sequence is -48 V to -48 V, +RTN to +RTN, then ground to ground. The ground wire should always be connected first and disconnected last.

■Do not work on the system or connect or disconnect cables during electrical storms.

■Before working on equipment that is connected to power lines, remove jewelry, including rings, necklaces, and watches. Metal objects heat up when connected to power and ground and can cause serious burns or become welded to the terminals.

■

■

Failure to observe these safety warnings can result in serious physical injury.

AC power cable warning (Japan):

WARNING: The attached power cable is only for this product. Do not use the cable for another product.

16■ Safety Warnings