Ssid

General Connection Setting
Channel	Selects the radio channel to be used for wireless networking.
	The channel setting of the wireless stations within a network
	should be the same.

Parameter	Description
Tx Rate	There are several options including
	Auto/1/2/5.5/11/6/9/12/18/24/36/48/54Mbps for you to select.
	When the “Auto” is selected, the device will choose the most
	suitable transmission rate automatically. The higher data rate
	you designated in the network, the shorter distance is allowed
	between the adapter and the wireless stations.
	When the adapter works in 11b mode, the maximum data rate
	is 11Mbps so that there are only “Auto/1/2/5.5/11Mbps”
	options you can select.
SSID	The SSID (up to 32 printable ASCII characters) is the unique
	name identified in a WLAN. The ID prevents the unintentional
	merging of two co-located WLANs.
	You may specify a SSID for the adapter and then only the
	device with the same SSID can interconnect to the adapter.
Any	If “Any“ check box is enabled, the adapter will survey and
	connect to one of the available wireless stations without
	checking the consistency of channel and SSID with the
	wireless station.
Network Type	Ad-Hoc– This mode enables wireless network adapters to
	connect without use of an AP or Router. Select this mode if
	there is no AP or Router in the network.
	Infrastructure – This operation mode requires the presence
	of an 802.11 Access Point. All communication is done via the
	Access Point or Router.
Change/Apply	Clicking “Change/Apply“ will allow the configuration of the
	parameters in the “General Connection Setting“ tab. Clicking
	Apply will confirm and enable the adjusted settings.
Encryption Setting	In this block, users may enable/disable WEP and WPA
	encryption within the network. Please refer to Section
	3.3 for a more detailed description.