Thank You, Installation Overview | Humminbird 530521-2

Transducer Switch

Thank You

Thank you for choosing Humminbird®, America's #1 name in fishfinders. Humminbird® has built its reputation by designing and manufacturing top-quality, thoroughly reliable marine equipment. Genuine Humminbird® accessories offer the opportunity to upgrade and expand the capabilities of your Humminbird® product.

Your Humminbird® accessory is designed for trouble-free use in even the harshest marine environment. In the unlikely event that your Humminbird® accessory does require repairs, we offer an exclusive Service Policy - free of charge during the first year after purchase, and available at a reasonable rate after the one-year period. For complete details, see the Warranty section included in this manual.

Contact our Customer Resource Center at 1-800-633-1468or visit our web site at www.humminbird.com.

Installation Overview

Following are instructions for the installation of this accessory. Before you start installation, we encourage you to read these instructions carefully in order to get the full benefit from your Humminbird® accessory.

If you find that any items are missing from your installation kit, call our Customer Resource Center at 1-800-633-1468or visit our web site at www.humminbird.com.

The Transducer Switch comes with all the necessary hardware to allow you to connect your control head to two transducers. The transducers may be the same type of transducer with different mounting locations, or you can maximize your unit’s performance by using two different transducers. The switch is intended for installation on the console, and will work well on almost any boat.

In addition to the hardware supplied with your Transducer Switch, you will need a hand drill with various size bits, a Phillips screwdriver, and an adjustable wrench.

Before installing the Transducer Switch, gather all the parts you will need, and make sure that the planned location of the Transducer Switch will allow you to connect the two transducers to your control head.

Installation

Perform the procedures in the following sections to install the Transducer Switch on your boat.

1.Locating the Transducer Switch Mounting Position

To determine where to mount the Transducer Switch, make sure that it will be positioned near your control head on the console of the boat, within reach of the cables for both transducers.

After you have determined the best mounting location for your Transducer Switch, proceed with the following instructions.

2.Attaching the Transducer Switch

1.Remove the switch plate from the switch assembly.

2.Using the switch plate as a template, mark the location of the hole with a pencil or punch.

3.Drill a 1/2” mounting hole at the desired location.

4.Test the fit of the Transducer Switch in the mounting location.

5.Remove the paper from the back of the switch cover to expose the adhesive backing and press the switch plate onto the mounting location.

530521-2_C

Transducer Switch With Cover

TRANSDUCER SELECTOR

A B

Switch Assembly

Boat Console

Switch

	TRA
A	NSD
	UCER
	SELE	CTOR
		CTOR

Switch Cover

Rubber Boot