Grizzly T24101 manual Parts Breakdown

Thermal Relay Overload Amp	When pushed, the contactor	ON	Button:	When	pushed,
Adjustment Dial: Turn this dial	is manually closed for trouble-	power is sent to the			magnetic
to the amperage setting speci-	shooting purposes only.	field	coil, closing the		contactor
fied by the motor manufacturer.		and sending power to the motor.
Typically, this setting is 100–
110% of the amperage load listed
on the motor data plate. Please		Manual/Auto Reset Lever: In
note that turning this dial has		the up position, the thermal relay
no effect on increasing motor		is in manual reset mode. This
horsepower. If turned too high,		means you must re-install the
the motor can overheat and be		outside cover and push the red
damaged before the relay trips.		OFF button, then push the green
		ON button to reset the thermal
Trip Indicator: If this window		relay. In the down position, the
		thermal relay		will automatically
turns yellow, the thermal relay		reset when it has cooled.
has tripped.
Manual Trip Test Lever: If the		Reset Button: When			pushed,
thermal relay function is in ques-		the thermal relay is reset, clear-
tion, run the motor and use a		ing the yellow trip indicator win-
wooden toothpick to slide the		dow.
yellow test lever to the left. If the
motor shuts off, the thermal relay
has tripped and is functional.	OFF Button: When pushed, the current going to the magnetic field
	coil is cut, which opens the contactor and cuts power to the motor.

Parts Breakdown

10

11

1

9

3

412 8

6 7

52

Parts breakdown provided for reference only. Not all parts shown are available for purchase.

REF	DESCRIPTION
1	SWITCH BOX
2	SWITCH BOX COVER ASSEMBLY
3	CONTACTOR TECO CU-16 230V
4	FIELD SWITCH TECO CNA-1
5	OL RELAY TECO RHU-10K1 21-25A
6	GROUNDING PLATE

REF	DESCRIPTION
7	PHLP HD SCR M3-.5 X 10
8	CAPTURED GROUND SCR M4-.7 X 10
9	PHLP HD SCR 10-24 X 1-1/2
10	LIQUID-TITE STRAIN RELIEF
11	RUBBER SEAL
12	PLASTC SCREW M10-1.5 X 20 GRAY

-2- T24101 Magnetic Switch