GN 8110 USB Set Up
System Requirements |
| Connect the GN 8110 USB to your | ||
The | Computer - Windows 98 SE and 2000 | |||
|
| |||
• Windows 98 SE (Second Edition) |
| Turn on your computer and let it complete the | ||
• Windows 2000 |
| |||
| Make sure that you are not running any applications. | |||
• Windows ME (Millennium Edition) |
| |||
|
|
| ||
• Macintosh OS 9.0.4 or greater. |
| Plug the USB connector | from the | |
You must have an available USB port. The | ||||
available USB port on the computer. Your headset does not need | ||||
not work with earlier releases of these operating systems. |
| |||
| to be plugged in at this time. The first time Windows detects that | |||
|
| |||
For the latest information on compatibility and use of this |
| the device is connected, it recognizes that there is new hardware | ||
| required and automatically launches the Add New Hardware | |||
product, go to the GN Netcom USB informational site at |
| |||
| Wizard. |
| ||
www.gnnetcom.com/usb. |
|
| ||
|
|
| ||
General |
| The Add New Hardware Wizard will launch three (3) times, | ||
| installing the following drivers: |
| ||
For Windows ME or Macintosh OS 9.0.4: You do not need to | • USB Composite Device (INF\USB\INF) | |||
install any software. Simply plug the USB connector | into | • USB Human Interface Device (INF\HIDDEV.INF) | ||
any USB port on the computer. |
| • USB Audio Device (INF\WDMA_USB.INF) | ||
For Windows 98 SE and Windows 2000: To use the GN8110- | These drivers are typically | |||
USB the first time, you need to install the USB drivers necessary | software is needed. If you upgraded your system to Windows 98 | |||
for the computer to recognize the device. |
| SE or Windows ME, you may need to use the upgrade disk during | ||
|
| this installation. |
| |