GN Netcom GN 9330, GN9350 manual Switching a call from desk telephone handset to headset

•Press the headset’s talk button.

•Press the base’s telephone mode button.

–> The headset’s link indicator will stop flashing to indicate that the headset-base link has been closed.

Important: If using electronic hookswitch on your telephone, do not place the headset into the charging cradle, and do not press the headset´s talk button or press the base´s telephone mode button, as this will disconnect the call.

If the headset runs out of battery power, the headset-base link will remain active for up to 2 minutes to allow for battery changing.

GN 9350 GN 9330 GN 9330 USB

4.6Switching a call from desk telephone handset to headset

It’s possible to switch a call in progress from the telephone’s handset to the headset:

1.Remove the headset from base, or if already out, press the headset’s talk button. This establishes a link.

–> The headset’s link indicator will start flashing and the call will be switched to the headset.

Note: Do not place handset before the call is over, as this will end the call.

GN 9350 GN 9330 GN 9330 USB

4.7New master headset pairing to base

You may designate a new master headset for your base.

Important: Before designating a new master headset, ensure that the original headset’s link to the base unit is closed by

pressing its talk button. The telephone or USB indicator should not flash.

'

(

To designate a new master headset:

1.Place the new master headset into the charging cradle of the base.

2.Press the base’s pairing button.

–> Both the telephone and USB mode buttons on the base, and the headset’s link indica- tor, will light for 2 seconds. This indicates successful pairing of the new master headset.

13