GE Monogram ZSC2001FSS dimensions Dimensions in inches, Electrical Requirements

Page 1

ZSC2001FSS – GE Monogram Built-In AdvantiumOven

Dimensions (in inches)

28-7/16"

15"

 

27/32"

 

(Recessed

 

14-1/8"

 

 

Portion)

 

9/16"

 

 

 

 

 

 

20-27/32"

 

 

 

21-7/8"

 

27/32"

 

 

 

 

13"

15-27/32"*

29-25/32"

7/8"

15/32"

11/16"

 

 

*Excludes Handle

Electrical Requirements

Single Speedcook Installation

Product rating is 120/208 or 120/240 volt, 60 Hz, 30 amps. This product must be connected to a supply circuit of the proper voltage and frequency and protected by a time delay fuse or circuit breaker. The power supply should be brought to a separate 30 ampere branch circuit. Wire size must conform to the requirements of the National Electric Code or the prevailing local code.

Combined Speedcook and Wall Oven Installation:

When installed in combination with a GE single wall oven, use separate electrical junction boxes,

OR,

Install a single junction box connected to 50 amp supply circuit or properly rated supply circuit.

Refer to single oven installation instructions for electrical requirements of that product.

These connections must be made by a qualified electrician. All electrical connections must meet National Electrical code or prevailing local codes.

Combined Speedcook and Warming Drawer Installation:

When installing the Speedcook oven over a GE electric warming drawer, a separate 120V, 60Hz, properly grounded receptacle must be installed. See instructions packed with the warming drawer.

Installation Requirements

These ovens may be installed directly into a wall or wall oven cabinetry, 30" minimum width.

The front surface of the oven will be nearly flush with surrounding cabinetry doors.

This oven can be installed over any GE single electric built-in oven or a single GE electric built-in warming drawer.

This oven must be installed at least 36" above the floor.

IMPORTANT: This oven is not approved for use above another built-in Speedcook oven, side by side or under the countertop installations.

For personal safety, this oven cannot be installed in a cabinet arrangement such as an island

or peninsula.

Cabinets installed adjacent to wall ovens must have an adhesion spec of at least 194°F temperature rating.

Allow for clearance to adjacent corners, walls, drawers, etc.

Listed by

Underwriters

RLaboratories

 

For answers to your Monogram,® GE Profileor

 

GE appliance questions, visit our website at

Specification Created 9/02

GEAppliances.com or call

GE Answer Center® service, 800.626.2000.

Image 1
Contents Installation Requirements Dimensions in inchesElectrical Requirements Speedcook Oven Installation above a GE Warming Drawer Single Speedcook InstallationSpeedcook Oven Installation above a GE Built-In Wall Oven Features and Benefits