Single Speedcook Installation

ZSC2001FSS – GE Monogram Built-In Advantium™ Oven

Speedcook Oven Installation above a GE Warming Drawer

30" 19" Min

28-1/2"

21"

Construct Solid

Bottom Min. 3/8" Plywood Supported by

2 x 4 or 1 x 2 Runners, all Four Sides

36-3/4" Min.

Required

30"24" Min.

28-1/2"

21"

9-1/4"

36-3/4" Min.

Construct Solid Bottom Min. 3/8" Plywood Supported by

2 x 4 or 1 x 2 Runners, all Four Sides

2" Min.

Install 2 x 4 or 2 x 2 Runners or Solid Bottom, Must Support 100 lbs.

Order a 30" wide single oven cabinet or cut the opening in a wall to dimensions shown.

The rough opening must be:

• Depth – 19" Min.

• Width – 28-1/2" Min.

• Height – 21" Min.

Note: Additional clearance between the cutouts may be required. Check to be sure the oven supports above the warming drawer location do not obstruct the required interior 23-1/2" depth and 9-1/4" height. See installation instructions for details.

Speedcook Oven Installation above a GE Built-In Wall Oven

• 36-3/4" from the floor to the cutout is required.

• These ovens require 3/4" overlap on each side, top

and bottom of the cutout.

• Oven overlaps will conceal cut edges on all sides

of the opening.

30"24" Min.

28-1/2"

21"

Construct Solid Bottom Min. 3/8" Plywood Supported by

2 x 4 or 1 x 2 Runners, all Four Sides

2" Min.

Per Oven

Requirement

Specification Created 9/02

*45-1/4"

Listed by

Underwriters

RLaboratories

For answers to your Monogram,® GE Profile™ or GE appliance questions, visit our website at GEAppliances.com or call

GE Answer Center® service, 800.626.2000.