GE TS0861 dimensions Testing

Page 5

Testing

Note — LED operation is configurable via the TS0862 Smart

 

Door Controller. Refer to the TS0862 Smart Door Controller

 

Installation & Programming Guide for details.

 

The following process checks a typical installation of a

 

TS0861 Magnetic Swipe Card Reader interfacing with a

 

TS0862 Smart Door Controller.

 

Check for correct operation:

1. Set the door to the ‘Access’ state and check that the Green LED (LED 1) is illuminated.

2. Swipe a suitable Magnetic Swipe Card through the TS0861. The Green LED flashes.

3. Set the door to the ‘Secure’ state and check that the Red LED (LED 2) is illuminated.

4. Swipe a suitable Magnetic Swipe Card through the TS0861. The Green LED flashes.

TS0861 Magnetic Swipe Card Reader Installation Guide

5

Image 5
Contents Contents Installation KitDescription Dimensions Installation OverviewDetails will vary when installing to other interfaces Connections MountingKey to J2 wiring block on TS0862 Testing TS0861 Magnetic Swipe Card Reader Installation Guide TS0861 Magnetic Swipe Card Reader Installation Guide Technical Support Disclaimer