Gefen EXT-DVIKVM-441DL user manual Using SHORT-CUT Characters to Change Settings

Page 24

RS-232 SERIAL CONTROL COMMANDS

2. USING SHORT-CUT CHARACTERS TO CHANGE SETTINGS

2.1 HYPERTERMINALtm SETTINGS in Microsoft Windowstm

First, please set up the correct communication conﬁguration by running these commands (as shown on the screen shot immediately below):

File->Properties->Setting->ASCII Setup

Also, please be sure to unmark the check box that says “Send line ends with line feeds.”

2.2 EXAMPLE -- CHANGE THE ROUTED SOURCE

Now you are ready to route Display input sources.

At the Hyperterminal cursor prompt, type the numeral key of the input to switch to, followed by the ENTER key.

Wait until you see the message “Function Done” on the Display. At this point the Display should show the correct Source corresponding to the numeral that was typed.

21

Image 24

Contents 4x1 Dvikvm DL/SL Switcher Asking for Assistance Technical SupportTechnical Support Hours Write ToContents Gefen 4x1 DVI KVM DL/SL Switcher IntroductionGefen How It WorksOperation Notes Features FeaturesPackage Includes Panel Layout Front Panel Back PanelPanel Descriptions Connecting and Operating the 4X1 DVI KVM DL/SL Switcher How to Connect the 4x1 DVI KVM DL/SL SwitcherWiring Diagram for the 4x1 DVI KVM DL/SL Switcher RMT-4IR Remote Control Description LED Indicator Input Selection Buttons4X1 DVI KVM DL/SL Switcher Remote Installation Empty Battery Slot IR Code Dip SwitchesRMT-4IR Remote and 4X1 KVM Switcher Configuration How to Resolve IR Code ConﬂictsWhat is Edid and what is it used for? Managing Edid with the 4x1 DVI KVM DL/SL SwitcherEdid Modes Local Edid Mode OFF Switch 3 = on Edid Lock Mode DIP Switch 4 = onEdid Modes FunctionDL Dual Link and SL Single Link Mode Switch=OFF Default DL Dual Link Only Mode Switch=ONDL Dual Link only Modes DL Dual Link Only ModesHow do I use these features? What are the RS-232 communications port settings?RS-232 Serial Control RS-232 Serial Control Commands RS-232 FeaturesFunctions Syntax Function Description#EDIDDSTOLO Function #EDIDDSTOBA Function#EDIDBATOLO Function #DDCTODS Function #DDCTOLO Function#DEF Function #LOEDIDTOBA Function #LOEDIDTOBA param1 param2 param3#LOEDIDTOLO Function #PRBAEDID Function#PRDSEDID Function #PRLOEDID FunctionCommand Description Input BinaryUsing SHORT-CUT Characters to Change Settings HYPERTERMINALtm Settings in Microsoft WindowstmRack Mount Installation Specifications 5V DCWarranty Product RegistrationPage Page Page Rev A6 Nordhoff St., Chatsworth CA