Singer ACC-31 installation manual Procedure for Horizontal Installation

INSTALLATION

The unit can be installed horizontally (position H), or vertically at a 90° angle (position V). The position of the built-in anti-vibration springs (left and right side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration compensation will not be effective and vibration may cause the disc to skip.

HORIZONTAL INSTALLATION
Set the anti-vibration springs to
position "H".	POSITION	POSITION
	"H"	"V"

VERTICAL INSTALLAITON Set the anti-vibration springs to position "V".

PROCEDURE FOR HORIZONTAL INSTALLATION

1

Attach a mounting bracket to each side of the unit, using the hex head bolts and washers.

NOTE: Make sure anti-vibration springs are set to position "H" as shown above.

		ACC31
D
IGITAL
COMPACTAUDIO	6	DISC
DISC
	CHA
		NGER

Hex head bolts and washers

BY AUDIOVOX

Bracket

2 Determine the mounting location and drill two mounting holes.

NOTE: If mounting surface is carpeted, use caution when drilling holes to prevent drill bit from catching on carpet. Cut holes in carpet before drilling into sub-surface.

WARNING

Never mount the unit near the fuel tank.

3 Secure the unit in place, using two self-tapping Phillips head screws.

Use RTV (silicone sealer) on screw threads or around the holes to prevent moisture intrusion.

				ACC31
D
IGITAL		AUDIO
COMPA				6
	CT D
			ISC CHDISC
				ANGER

Carpet

Drill holes 1/8" (4mm) in diameter.

Self-tapping Phillips head screw

BY AUDIOVOX

Bracket

4

Bracket