Singer ACC-31 Procedure for Vertical Installation, Bracket Hex head bolt and washer

PROCEDURE FOR VERTICAL INSTALLATION

Note

If the anti-vibration spring position has been changed and verified for vertical mounting (as shown on page 4), start with step 2.

1	Set the anti-vibration springs to position "V"	2	Attach a mounting bracket to each side of the unit, using
	as shown below .		the hex head bolts and washers.

POSITION "V"

Bracket

Bracket

Hex head bolt and washer

3	Determine the mounting location and drill two mounting holes.		4	Mount the unit in place, using two self-tapping Phillips head
				screws.
				Use RTV (silicone sealer) on screw threads or around
				the holes to prevent moisture intrusion.
	NOTE: If mounting surface is carpeted, use caution
		when drilling holes to prevent drill bit from
		catching on carpet. Cut holes in carpet
		before drilling into sub-surface.		Self-tapping
				Phillips head
		WARNING
				screw
		Never mount the unit near the fuel tank.

Bracket	Bracket
Carpet

Drill holes 1/8" (4mm) in diameter.

Hex head bolt and washer

5