Operation Notes

READ THESE NOTES BEFORE INSTALLING OR

OPERATING THE USB•100 SYSTEM.

*The USB•100 send and receive were designed to operate on USB enabled computers. DO NOT attempt to use this equipment with any other type of computer.

*Use the computer's USB port when using a local keyboard that is not extended with the USB•100 sender unit.

*In order to operate properly, the USB•100 receiver unit must be connected, powered, and the CAT-5 cable must be installed between the send and receive units.

*Only dedicated Category 5 UTP type cable (CAT-5) is recommended for this application (pin to pin).

*The length of cable used to connect the USB•100S send unit to the USB•100R receiver unit MUST NOT EXCEED 330 feet.