Faria Serial Bus Gateway
Water Pressure Connection
P13 |
|
| P9 | P7 | P5 | P4 | P1 |
P15 | P12 | P11 |
|
|
|
|
|
P14 |
| P10 | P8 |
| P6 | P3 | P2 |
|
|
| |||||
|
|
|
|
|
|
Water Pressure
Fitting on the
Evinrude Engine
Figure 7
Diagnostic Port Connection
P13 |
|
| P9 | P7 |
P15 | P12 | P11 |
|
|
P14 |
| P10 | P8 | P6 |
|
|
To use the Evinrude diagnostic test equipment, you must remove the “Jumper Plug” from P7 and then connect the diagnostic unit at P7.
With the diagnostic unit plugged in, the system is now in the Diagnostic Mode. Normal diagnostic procedures should be followed.
Note: Instruments are disabled in the Diagnostic Mode. To return to normal operation, replace the “Jumper Plug in P7. Turn off power to the “Gateway.” Reapply power. Serial Bus system is now in Normal Operation mode.
P5 P4 P1
P3 P2
Evinrude
Diagnostic
Computer
Figure 8 | Page14 |