3 TROUBLESHOOTING
Troubleshooting
|
| If a problem persists even after applying the suggested remedies, contact an | E | |||
|
| EIZO dealer. |
|
|
|
|
|
|
|
| |||
|
|
|
| |||
|
|
|
|
|
| |
|
| Problems | Points to check with possible solutions |
|
| |
1) Indicator status: OFF | Check that the power cord is correctly connected. |
| ||||
2) Indicator status: GREEN | Try pressing a key on the keyboard, or clicking the |
| ||||
|
|
| mouse. (The monitor may be in a power saving mode.) |
| ||
|
|
| Check brightness and contrast settings. Minimum |
| ||
|
|
| settings will cause screen to be blank. |
| ||
3) Indicator status: YELLOW | Try pressing a key on the keyboard, or clicking the |
| ||||
|
|
| mouse. (The monitor may be in a power saving mode.) |
| ||
4) Indicator status: YELLOW | Try pressing any keys on the front panel, or switch the |
| ||||
|
| (flashing) | monitor off and then on. (The monitor may be in “Off |
| ||
|
|
| Timer Mode”.) |
| ||
|
|
| If the problem persists, switch off the monitor power for a |
| ||
|
|
| few minutes, then switch it back on and try again. |
| ||
|
|
|
|
|
| |
5) Following message appears. | Check that the PC is switched ON. |
| ||||
|
|
| Check that the signal cable is properly connected to the |
| ||
|
|
| graphics board or PC. |
| ||
|
|
| Check that the graphics board is correctly inserted in |
| ||
|
|
| the PC. |
| ||
|
|
|
| |||
6) Following message appears. | Use the graphics board’ s utility software to change the |
| ||||
| (Example) | frequency setting. (Refer to the manual of the graphics |
| |||
|
|
| board.) |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
•Whenever an error signal message appears, the signal frequency will be displayed in red.
•Error messages shown above will remain on the screen for 30 seconds. An error message may not appear at all if the signal frequency is extremely high or extremely low.
7)The image vibrates on the screen.
Use of the “Moiré” adjustment may cause a slight vibration. To eliminate the vibration, set the adjust- ment level to lower percentage or 0%. See page 11.
Check that the signal cable is properly connected to the graphics board or PC.
Check that the graphics board is correctly mounted in the PC.
3 TROUBLESHOOTING 15