4)“No signal detected” error message appears.
5)“Out of range” error message appears.
(Example)
• Check that the PC is switched ON.
E
•Check that the signal cable is properly connected to the graphics board or PC.
•Check that the graphics board is correctly inserted in the PC.
•Switch the signal input by pushing the BNC/
•Use the graphics board’s utility software to change the frequency setting. (Refer to the manual of the graphics board.)
•Whenever an error signal message appears, the signal frequency will be displayed in red.
•Error messages will remain on the screen for 30 seconds, and then disappear. An error message may not appear at all if the signal frequency is extremely high or extremely low.
Imaging problems
1)Display size and/or position is incorrect.
•Press the
•Adjust the image size and/or position using the icons in the ScreenManager 'Screen' menu. See page 9.
2)• The image vibrates on the screen.
•A slight shaking movement of the screen image or text.
•Use of the “moiré reduction” feature may cause a slight vibration. To eliminate the vibration, switch the feature OFF or reduce the moiré reduction level. See page 10.
•Check that the signal cable is properly connected to the graphics board or PC.
•Check that the graphics board is correctly mounted in the PC.
7 TROUBLESHOOTING 31