This function is used to select which PC will have priority to control the monitor when utilizing two PCs. The monitor constantly checks the input signals and switches automatically in accordance with the "Input Priority" setting (see table below). Once a priority is set, whenever a change of signal is detected at the selected input, the monitor will switch the input to that signal.
In the case of only one signal being present at either input, the monitor automatically detects and displays that signal.
Priority setting |
| Performance |
1
(SIGNAL 1 -
2
(SIGNAL 2 -
Manual
If signals from both inputs are present, the monitor gives preference to Signal 1 in the following cases.
●When the power of the monitor is turned ON.
●When the signal input to Signal 1 is changed even if active input was Signal 2 (Analog input only).
If signals from both inputs are present, the monitor gives preference to Signal 2 in the following cases.
●When the power of the monitor is turned ON.
●When the signal input to Signal 2 is changed even if active input was Signal 1 (Analog input only).
The monitor will not detect signals automatically in this mode. Select the active input by pressing the Input Signal Selection Button on the monitor's control panel.
●When the "1" or "2" is selected, the power saving mode of the monitor activates only if both PCs are in power saving mode.