Fortinet 310B manual Further Reading, Document conventions, Typographic conventions, Addressipv4

Page 9

 

 

 

Introduction

Further Reading

FortiGate Firmware – Describes how to install, update, restore and test firmware for the FortiGate device.

AMC modules – Describes inserting, removing and using Fortinet AMC single- width modules in the FortiGate unit.

Document conventions

The following document conventions are used in this guide:

In the examples, private IP addresses are used for both private and public IP addresses.

Notes and Cautions are used to provide important information:

Note: Highlights useful additional information.

Caution: Warns you about commands or procedures that could have unexpected or ! undesirable results including loss of data or damage to equipment.

Typographic conventions

FortiGate documentation uses the following typographical conventions:

Convention

Example

 

 

Keyboard input

In the Gateway Name field, type a name for the remote VPN

 

peer or client (for example, Central_Office_1).

Code examples

config sys global

 

set ips-open enable

 

end

CLI command syntax

config firewall policy

 

edit id_integer

 

set http_retry_count <retry_integer>

 

set natip <address_ipv4mask>

 

end

Document names

FortiGate Administration Guide

 

 

Menu commands

Go to VPN > IPSEC > Phase 1 and select Create New.

 

 

Program output

Welcome!

Variables

<address_ipv4>

Further Reading

The most up-to-date publications and previous releases of Fortinet product documentation are available from the Fortinet Technical Documentation web site at http://docs.forticare.com.

The following FortiGate product documentation is available:

FortiGate QuickStart Guide

Provides basic information about connecting and installing a FortiGate unit.

FortiGate-310B FortiOS 3.0 MR6 Install Guide

 

01-30006-0472-20080815

9

Image 9
Contents Install G U I D E Regulatory compliance TrademarksContents Configuring Transparent mode Protection profiles Firewall policiesDownloading firmware Using the CLI Using the web-based managerInstalling firmware from a system reboot using the CLI Testing new firmware before installingPage Register your FortiGate unit IntroductionLacp configuration About the FortiGate-310BAbout this document Document conventions Further ReadingTypographic conventions Addressipv4Fortinet Knowledge Center FortiGate Administration GuideComments on Fortinet technical documentation Customer service and technical supportCustomer service and technical support Environmental specifications InstallingGrounding Rack mount instructionsMounting Installed mounting brackets To install the FortiGate unit into a rackTo power on the FortiGate unit Connecting to the networkTo power off the FortiGate unit Plugging in the FortiGateConfiguring NAT vs. Transparent modeNAT mode Transparent mode Connecting to the FortiGate unitConnecting to the web-based manager To connect to the web-based managerTo connect to the CLI Connecting to the CLIBits per second 9600 Data bits Parity Stop bits Flow controlUsing the web-based manager Configuring NAT modeConfigure the interfaces To configure interfaces Go to System Network InterfaceConfigure a DNS server Adding a default route and gatewayInitial Padt Timeout Adding firewall policies To modify the default gateway Go to Router StaticSource Interface Source Address AllUsing the CLI To set an interface to use a static addressTo set an interface to use Dhcp addressing To set an interface to use PPPoE addressing To configure DNS server settingsTo add an outgoing traffic firewall policy To modify the default gatewayConfiguring Transparent mode Switching to Transparent modeTo switch to Transparent mode Go to System Status Source Address All Destination Interface To switch to Transparent mode Backing up the configuration Verify the configurationAdditional configuration Restoring a configurationSet the Administrator password Set the time and dateUpdating antivirus and IPS signatures Configure FortiGuardAdditional configuration Advanced configuration Default protection profilesProtection profiles Firewall policies Firewall policiesAntivirus options Configuring firewall policiesAntiSpam options Web filtering Logging Installing modules Installing AMC filler unitsTo install the filler module AMC modulesRemoving modules Using the AMC modulesHard disk module To insert a module into a FortiGate chassisTo format the ASM-S08 hard disk enter the following command Log configuration using the web-based managerFormatting the hard disk Execute formatlogdiskChanging interfaces to operate in Sgmii or SerDes mode Log configuration using the CLIViewing logs ASM-FB4 and ADM-XB2 modulesConfig system interface edit AMC-SW1/1 Set speed auto End Configure the speedUsing the AMC modules Downloading firmware FortiGate FirmwareUsing the web-based manager Upgrading the firmwareReverting to a previous version Backup and Restore from a USB key Using the USB Auto-InstallTo revert to a previous firmware version Using the CLI To upgrade the firmware using the CLIExecute ping Execute restore image image.out Execute restore image namestr tftpip4Execute update-now To revert to a previous firmware version using the CLIExecute restore image namestr tftpipv4 Installing firmware from a system reboot using the CLIExecute restore image image28.out Execute restore config namestr tftpip4Execute reboot To install firmware from a system rebootPress any key to display configuration menu Enter Tftp server addressTo backup configuration using the CLI Restoring the previous configurationEnter Local Address Enter File Name image.outAdditional CLI Commands for a USB key To restore configuration using the CLITo configure the USB Auto-Install using the CLI To test the new firmware image Testing new firmware before installingTesting new firmware before installing Testing new firmware before installing Index Web filtering 37 web-based manager Page Page

310B specifications

The Fortinet 310B is a powerful next-generation firewall (NGFW) designed to meet the evolving needs of modern enterprises. As part of Fortinet's Security Fabric, the 310B offers robust security features combined with high performance, enhancing network security while maintaining ease of use.

One of the standout features of the Fortinet 310B is its high throughput capability. With up to 10 Gbps of firewall throughput and an impressive IPS throughput of 3.5 Gbps, the device is optimized for handling heavy network traffic with minimal latency. This makes it suitable for both medium and large-scale environments, where performance and speed are critical.

The Fortinet 310B integrates a comprehensive suite of security technologies. At its core is FortiOS, the operating system that powers Fortinet’s security appliances. FortiOS includes advanced threat protection capabilities such as intrusion prevention system (IPS), deep packet inspection, and antivirus scanning. These features help protect against a wide range of threats, including malware, ransomware, and zero-day attacks, ensuring that networks are resilient against various cyber threats.

Another key characteristic of the Fortinet 310B is its multi-layered security architecture. The device supports a range of technologies such as SSL inspection, web filtering, and application control. By leveraging these functionalities, organizations can enforce granular security policies across different applications and users, improving overall visibility and control over the network environment.

The Fortinet 310B also incorporates FortiGate's unique Security Fabric technology, which enables seamless integration with other Fortinet products and third-party solutions. This interoperability allows for centralized management, simplified security operations, and enhanced threat intelligence sharing, creating a holistic security approach.

In addition to its security capabilities, the Fortinet 310B offers a variety of connectivity options, including multiple Ethernet ports and support for FortiLink, which allows for easy integration with FortiAP access points and FortiSwitches. This flexibility facilitates the deployment of secure network segments and wireless solutions.

The device also supports advanced features such as VPN capabilities for secure remote access, SD-WAN for optimizing network performance, and extensive reporting and logging for compliance and accountability. All these attributes make the Fortinet 310B a formidable choice for organizations looking to bolster their network security posture while maximizing operational efficiency. Overall, the Fortinet 310B stands out as a reliable and versatile solution in the realm of network security appliances.