Enterasys Networks RBT-1002C-EU, RBT-1002-EU manual Compliances

Page 17

COMPLIANCES

Countries of Operation & Conditions of Use in the Asia, Pacific, and Middle East Communities

This device is intended to be operated in all countries listed below of the Asia, Pacific, and Middle East Community. Requirements for indoor vs. outdoor operation, license requirements and allowed channels of operation apply in some countries as described below:

Note: The user must use the configuration utility provided with this product to ensure the channels of operation are in conformance with the spectrum usage rules for countries as described below.

This device requires that the user or installer properly enter the current country of operation in the command line interface as described in the user guide, before operating this device.

This device will automatically limit the allowable channels determined by the current country of operation. Incorrectly entering the country of operation may result in illegal operation and may cause harmful interference to other system. The user is obligated to ensure the device is operating according to the channel limitations, indoor/outdoor restrictions and license requirements for each country as described in this document.

This device employs a radar detection feature required for operation in the 5 GHz band. The presence of nearby radar operation may result in temporary interruption of operation of this device.

The 5 GHz Turbo Mode feature is not allowed for operation in any of the countries. The current setting for this feature is found in the 5 GHz 802.11a Radio Settings Window as described in the user guide.

The 5 GHz radio's Auto Channel Select setting described in the user guide must always remain enabled to ensure that automatic 5 GHz channel selection complies with requirements. The current setting for this feature is found in the 5 GHz 802.11a Radio Settings Window as described in the user guide.

This device is restricted to indoor use when operated using the 5.15 - 5.25 GHz band: Channels 36, 40, 44, 48.

XV

Image 17 Contents
Enterasys RoamAbout Page Page You and Enterasys agree as follows Enterasys Networks, Inc Firmware License AgreementIII Page Page Page RBT-1002, RBT-1002-EU Wireless 5 GHz Band StatementsFederal Communication Commission Interference Statement FCC Radiation Exposure StatementIndustry Canada Class B Operating FrequenciesRBT-1002-EU EC Conformance DeclarationCompliances Operation Using 5 GHz Channels in the European Community Usage RBT-1002C, RBT-1002C-EU Xiii RBT-1002C-EUXIV Compliances XVI English Declaration of Conformity in Languages European CommunityXviii Power Cord Safety Safety CompliancePower Cord Set Hazardous Substances Xxii Table of Contents Xxiv Chapter Introduction Package Checklist Rear Panel Top PanelAntennas LED IndicatorsComponent Description LED Ethernet Port Security SlotConsole Port Power Connector Reset ButtonFeatures and Benefits Hardware Installation Hardware Installation Hardware Installation Hardware Installation Hardware Installation Bezel Appendix a Troubleshooting Troubleshooting Appendix B Configuration Configuration Twisted-Pair Cable Assignments Appendix C Cables and Pinouts10/100BASE-TX Pin Assignments Cables and PinoutsTwisted-Pair Cable Assignments Crossover Wiring Straight-Through Wiring802.11b/g RBT-1002 FCC/IC Appendix D SpecificationsMaximum Channels 802.11a RBT-1002 Operating Range Maximum ClientsData Rate Modulation TypeUnit Power Supply AC Power AdaptersWeight TemperatureSafety Radio Signal CertificationSensitivity CompliancesTransmit Power Ieee 802.11g Maximum Output Power GHz dBm Data Rate Index Index
Related manuals
Manual 28 pages 41.76 Kb