EnGenius Technologies user manual ESR-9710 Wireless N Gigabit Router

Page 43

ESR-9710 Wireless N Gigabit Router

Version 1.0

Address Mode: PPPoE can be used with a dynamic or static IP address. If you select the Dynamic IP radio button, then the IIP address in the next field is not required. However, if you select the Static IP radio button, then the IP address in the next field is required.

User Name: Specify the user name which is provided by your ISP.

Password: Specify the password which is provided by your ISP, and then verify it once again in the next field.

Service Name: Specify the name of the ISP.

Reconnect Mode: Select a reconnection time: Always on (A connection to the Internet is always maintained), On demand (A connection to the Internet is made as needed), Manual: You have to open up the Web-based management interface and click the Connect button manually any time that you wish to connect to the Internet.

Maximum Idle Time:

Primary / Secondary DNS Address: Specify the primary and secondary IP address, which is assigned by your ISP.

MTU: The Maximum Transmission Unit (MTU) is a parameter that determines the largest packet size (in bytes) that the router will send to the WAN. If LAN devices send larger packets, the router will break them into smaller packets. Ideally, you should set this to match the MTU of the connection to your ISP. Typical values are 1500 bytes for an Ethernet connection and 1492 bytes for a PPPoE connection. If the router's MTU is set too high, packets will be fragmented downstream. If the router's MTU is set too low, the router will fragment packets unnecessarily and in extreme cases may be unable to establish some connections. In either case, network performance can suffer.

MAC Address: If you need to change the MAC address of the rounter's WAN-side Ethernet interface, either type in an alternate MAC address (for example, the MAC address of the router initially connected to the ISP) or click on Clone Your PCs MAC Address.

Click on the Save Settings button to store these settings.

43

Image 43

Contents Wireless N Gigabit Router User’s Manual Table of Contents Appendix C FCC Interference Statement Appendix D Index Appendix a Glossary Appendix B SpecificationsRevision History Introduction Features & BenefitsSafety Guidelines Package ContentsWlan LED Wireless Soho Router DescriptionWAN LED Applications System RequirementsAd-hoc peer-to-peer Mode Network ConfigurationIP Address Configuration Hardware InstallationUnderstanding the Hardware PC IP address Logging Internet Connection WizardESR-9710 Wireless N Gigabit Router ESR-9710 Wireless N Gigabit Router Dhcp Connection Dynamic IP Address PPPoE Point-to-Point Protocol over Ethernet Pptp Point-to-Point Tunneling Protocol 4 L2TP Layer 2 Tunneling Protocol Static IP Address Configuration ESR-9710 Wireless N Gigabit Router BigPond Add a Wireless Device Wi-Fi Protected Setup WizardUsing the PIN Using the Push Button Wireless Network Setup Wireless Network Setup WizardManual Network Setup Automatic Network SetupESR-9710 Wireless N Gigabit Router Wireless Security Level Best WPA2 Wireless Security Level Better WPA Wireless Security Level Good WEP 64/128-bit Wireless Security Level None Security Disabled Advanced Web Configuration Basic WizardWirelessNetwork Settings Bridge ModeRouter Mode Wireless Settings WEP Wired Equivalent Privacy Wireless Security ModeWPA Personal Wi-Fi Protected Access WPA Enterprise Wi-Fi Protected Access ESR-9710 Wireless N Gigabit Router WAN Settings Dhcp Connection Dynamic IP Address PPPoE Point-to-Point Protocol over Ethernet ESR-9710 Wireless N Gigabit Router Pptp Point-to-Point Tunneling Protocol 4.5 L2TP Layer 2 Tunneling Protocol Address ESR-9710 Wireless N Gigabit Router Advanced Advanced WirelessVirtual Server Special Applications StreamEngine Port ForwardingESR-9710 Wireless N Gigabit Router ESR-9710 Wireless N Gigabit Router Routing Access ControlESR-9710 Wireless N Gigabit Router ESR-9710 Wireless N Gigabit Router MAC Address Filter Web FilterFirewall ESR-9710 Wireless N Gigabit Router ESR-9710 Wireless N Gigabit Router Inbound Filter Wish Wi-Fi Protected Setup Advanced Network UPNP, WAN Ping… ƒ Click on the Save Settings button to store these settings Tools Time Zone SettingSystem Save Configuration to a FileRestore the Configuration from a File System Reboot Restore Settings to DefaultSystem Logs Firmware UpgradeSystem Check Dynamic DNSSchedules Status Wireless StatusLogs Status Statistics Wish Session Status Internet Session Status Adsl Appendix a GlossaryAscii CAT BootpDhcp EAP DMZDNS DSLHttps FTPGUI HttpIPX IgmpIIS IKELPR/LPD L2TPLAN LEDOfdm NATNIC NTPRadius POP3PPP PptpSoho SIPSmtp SnmpURL TCP/IPTftp UDPWisp WCNWDS WEPHardware Summary Appendix B SpecificationsRouter and Gateway Management Environment & Physical Federal Communication Commission Interference Statement Appendix C FCC Interference StatementCD-ROM Appendix D IndexSystem Reboot, 3, 69 System Requirements, 2