DeWalt PLEBR10 manual Connecting the PowerLine Ethernet Bridge, Connecting the Bridge

Page 9

PowerLine Ethernet Bridge

Chapter 4: Connecting the PowerLine Ethernet Bridge

Connecting the Bridge

IMPORTANT: Do NOT use a switch to connect multiple powerline devices to your PC’s Ethernet port. Each powerline device should be connected to its own Ethernet port on the PC.

1. Plug the included Category 5 Ethernet network cable into the computer’s Ethernet port.

Figure 4-1: Ethernet Port on PC

2. Plug the other end of the cable into the Ethernet port of the Bridge.

Figure 4-2: Ethernet Port on Bridge

Chapter 4: Connecting the PowerLine Ethernet Bridge

5

Connecting the Bridge

Image 9

Contents Powerline Ethernet Bridge Copyright and Trademarks Table of Contents Top Panel PowerLine NetworkBut what does all of this mean? IntroductionWhat’s in this Guide? Network Topology Planning your PowerLine NetworkTop Panel Getting to Know the PowerLine BridgeConnecting the Bridge Connecting the PowerLine Ethernet BridgePlug the Bridge into an electrical outlet Connecting to a RouterUsing the PowerLine Configuration Utility Setup WizardOverview Installing Configuration Utility PowerLine Configuration Utility Icon Accessing the PowerLine Configuration UtilityNetwork Tab NetworkAbout SecurityAppendix a Troubleshooting Common Problems and SolutionsFrequently Asked Questions Appendix a Troubleshooting Frequently Asked Questions TCP/IP Appendix B Windows HelpAppendix C Glossary PowerLine Ethernet Bridge PowerLine Ethernet Bridge PowerLine Ethernet Bridge PowerLine Ethernet Bridge PowerLine Ethernet Bridge PowerLine Ethernet Bridge Appendix D Specifications Limited Warranty Appendix E Warranty InformationFCC Statement Appendix F Regulatory InformationAppendix G Contact Information