Wall Mount, FCC Compliance Statement

RJ-45 10/100 Dual Speed Ports

There are 8 RJ-45 ports on the front panel. The speed of the port is automatically determined when you connect the hub to 10Base-T and 100Base-TX devices.

Uplink Port

One uplink port (MDI) on the front panel allows users to connect to a switch or a hub, using straight-through Category 5 twisted-pair cable as figure shown.

Connecting to a desktop

The hub is connected to the desktops, to form a small network. You can build the network as the figure shows.

Connecting to a Switch or a Hub

Hub-to-hub connections are made by connecting the uplink port of the 10/100 dual speed hub to a port of the other hub/switch.

With 100Base-TX, the maximum network distance is approximately 205 meters with UTP cable. The maximum length between hubs or switch-to-hub is 100 meters.

WALL MOUNT

Wall

The MIL-H3130 10/100 Dual Speed Hub can be mounted to the wall or to a flat surface.

!Screw one of the enclosed 1/2-inch wood screws into the surface, leaving approximately 1/4-inch of the threads exposed.

!Hang the hub on the wall using the keyholes provided on the bottom of the hub.

FCC COMPLIANCE STATEMENT

This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the instructions provided with the equipment, may cause interference to radio and TV reception. The equipment has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation.

If you suspect this equipment is causing interference, turn your hub on and off while your radio or TV is showing

interference. If the interference disappears when you turn the hub off and reappears when you turn the hub on, something in the hub is causing interference.

You can try to correct the interference by one or more of the following measures:

•Reorient the receiving radio or TV antenna where this may be done safely.

•To the extent possible, relocate the radio, TV or other receiver away from the equipment.

•Plug the computer which has the equipment installed into a different power outlet so that the equipment and the receiver are on different branch circuits.