Digi MIL-3200X manual Installation, MIL-4300M Micro Module

Chapter 3

•MIL-4340M: 10BASE5, with an AUI connector (version B)

•MIL-4350M: 10BASE-FL multi-mode, with an SMA connector (versions A, B and C)

•MIL-4360M: Single-mode, half-duplex; with an ST connector (versions A and B)

•MIL-4370M: Single-mode, half- and full-duplex; with an ST connector (versions A and B)

M

I

16VAC

FTRX

Vacant Slot

PWCX

MIL•4320M

PWR SYS NET LNK

UTP

FT	RX
LK	CX

C R O

M O D U L E S

Figure 3-1. MIL-4300M Micro Module

3.4 Installation

Do the following to install any of the following micro module:

1.Use a phillips head screwdriver to remove the screws securing the faceplate of the base unit.

2.Remove the faceplate.

3.Make any configuration changes to the module.

4.Slide the module into the port.

MIL-3200X Series of FastPort Print Servers 3-3