Digi MIL-5008H manual Hardware Description, Front View

Install Guide

Hardware Description

The MIL-5008H series hub ships with the hub, an external power supply, four rubber feet (shipped loose) that the user may attach, and rack mount ears are also included.

The RJ-45 connectors and LEDs are located on the front panel of the hub. The power supply input (5VDC) is located on the rear panel. The hub is cooled by a fan. The air intake vent is located on the left with the fan outlet located on the right side of the unit. Care should be taken not to block these vents when installing the MIL-5008H.

The power supply consists of a capture 5VDC, 4A cable which connects to the hub, and a receptacle for a detached power cord. The power cord shipped with the unit depends on the destination country.

The LEDs give status information for the hub. The Link/Receive LED has three states, solid ON for link active and no data being received on that port, Blinking for link active and receiving data on that port, OFF for link not detected and no data being received. The partition LED is OFF when the port is active and ON when the port has been partitioned. The collision light is ON when collisions are happening, OFF when no collisions are sensed. The power LED ON indicates that the unit is receiving power.

The RJ-45 ports are configured for connection to end node devices. Use a swap cable to connect to another hub.

		Ethernet TX Hub II					MIL•5008H
1	2	3	4	5	6	7	8
			Link/Rx				Link/Rx Power
	open 2.34 x .535
			Partition				Partition Collision

Figure 1.Front View

Figure 2.Rear View

Model: MIL-5008H Fast Ethernet TX Hub 5