Digi MIL-5008H manual Specifications, Utp

Install Guide

By using a Digi MIL-180T converter, you convert the TX twisted pair signals to the FX fiber media. This allows you to extend the distance beyond 100 meters for a fiber segment. On the workstation side, connect either directly to the FX port or use the MIL-100FX transceiver to adapt the FX signals to MII.

		4	5
1 2	3			6	7 8

To connect the hub to another hub, switch, bridge or router, use a swap cable swapping pins 1 to 3, 2 to 6, 6 to 2, and 3 to 1.

RJ-45 Pin Assignment

Pin	Function	Pin	Function
1	RX +	5	NC
2	RX -	6	TX -
3	TX +	7	NC
4	NC	8	NC

NC = Not Connected, RX = Receive Data, TX = Transmit Data

Note: Don’t use NC pins for covering other network traffic or telephone signaling if the building is wired for 8 pins. It will degrade the performance of the 100MB operation.

Specifications
Conformance	IEEE 802.3u Class-II
	100BASE-TX
Ports	8 UTP
Interface	Shielded RJ-45
Dimensions	8.4" W x 1.7" H x 5.1" D
Shipping Weight
(including Power Supply)	1.5 lb.
Power Supply Requirements
Input	100VAC to 240VAC, 0.7A,
	50/60Hz
Output	5V DC, 4.0A
Operating Temperature	0° C to 50° C
Humidity (noncondensing)	5% to 90%

Model: MIL-5008H Fast Ethernet TX Hub 9