Digi 9P 9360/9750 manual Skipped

Each of these commands has additional help available, which can be viewed by entering help <command>.

All numeric values, which are needed for different commands, are interpreted as HEX values. Entering 30100000 means 0x30100000.To speed up programming, the real size of the image files can be used. In the commands above we have used the maximum size of the partition instead of the actual size of the image files (0x180000 words = 3 Mb)

The following table explains some of the more often used commands:

bootm ADDR ARG	boots image from ADDR passing arguments ARG. ARG is the
	address of the initrd image
boot, bootd	boots image via running default bootcmd
nand bad	prints a list of bad blocks on the current device
nand erase OFF SIZE	erase SIZE bytes from OFF
nand erase clean	erase entire NAND Flash
	WARNING: after this command, U-Boot has to be reprogrammed
nand read ADDR OFF SIZE	read SIZE bytes from OFF in NAND flash to ADDR. If there are
	bad blocks the command stops with an error.
nand read.jffs2s ADDR OFF SIZE	read SIZE bytes from OFF in NAND flash to ADDR. Bad blocks are
	skipped.
nand write ADDR OFF SIZE	write SIZE bytes from ADDR to OFF in NAND flash. If there are
	bad blocks or writing fails the command stops with an error.
nand write.jffs2 ADDR OFF SIZE	write SIZE bytes from ADDR to OFF in NAND flash. Bad blocks
	are skipped.
printenv	prints the environment variables
saveenv	stores the changed environment variables persistently
	sets the environment variable VARIABLE to the given value
setenv VARIABLE VALUE	VALUE. If a semicolon is used, to set different variables, it has to
	be masked with “\”
run VARIABLE	executes the commands of VARIABLE like a script
tftp ADDR image	loads image to ADDR via network using TFTP and the environment
	variables “ipaddr” and “serverip”
usb reset	enables and resets the USB interface
usb scan	scans the bus for attached USB storage devices
usb tree	shows the connected devices

7 3